How to use the remote to control your tv – Hitachi 51SWX20B User Manual

Page 23

HOW TO USE THE REMOTE TO CONTROL YOUR TV

ቮ

C.C. button
Press this button to quickly turn the Closed Caption feature on, off and auto. You can also access this feature on the Setup menu.
(See age 62).

ቨ

CD, TAPE, AMP buttons
When pressed, each of these buttons will blink to indicate the remote is in Audio mode. (see page 35)

ቩ

CHANNEL selector buttons
CHANNEL selector buttons are used to select channels, lock access code, etc.
Enter one, two, or three numbers to select channels. Enter “0” first for channels 1 to 9, or simply press the single digit channel you
wish to tune then wait a few seconds for the TV to tune. For channels 100 and above, press the “1” button, wait until two dashes
appear next to the channel display on your TV, then enter the remaining two numbers using the number buttons.
Channel selection may also be performed by pressing CH up (

) or down (

ቪ

SLEEP button
Press this button to display the sleep timer in the lower left corner of the screen. Every subsequent press of this button will add 15
minutes to this timer, up to a maximum of three hours. Once set, use STATUS when you want to view time remaining. If the SLEEP
button is pressed while the timer is set, it will reset to the original condition.

ቫ

INFO button
Press this button when you want to check the channel being received, the picture source, if the channel has stereo (ST) or second
audio program (SAP), the time, CHANNEL ID and if the SLEEP timer is set.

ቭ

ANTENNA button
The ANT button will select between Antenna A and Antenna B each time the button is pressed.

NOTE:

The TV may not receive some channels if you are not in the correct ANTENNA/CABLE mode. (see page 57)

Stereo (480i)

ST/SA

Audio

Broadcast

Audio Selected

Main Picture Source

Channel ID/Video ID

Time

PIP/Sub-Picture
Source

Signal Format

Received

TV-PG DLSV

PIP TV-PG DLSV

Broadcast

Rating

16:9 Standard
1080i
Movies
C.C. On
Off 10:05 AM
Time Out 10:05 AM
Sleep 0:01

Wide

Mode

Virtual

Picture

Mode

Closed

Captioning

Off Timer

TV Time Out

Sleep Timer

Ant A 15

ABCDEFG

10:10 AM

PIP Ant C 46-1234

PIP/Sub-Picture

OFF

When an S-VIDEO
Input is connected to
VIDEO: 3.

When a COMPONENT
VIDEO: Y-PBPR Input

is connected to
VIDEO: 1.

S - IN: 3

Ant B 28

Ant A 10

ANT