Husqvarna 325HDA65X-Series - Manual (Page 17)

English – 17
WORKING TECHNIQUES
• Tighten the knob.
(325HE3,325HE4)
• Loosen the knob on the shaft (clockwise).
• Press the cutting unit against the hedge or some other
firm surface until the required angle is set.
• Turn the knob (anti-clockwise).
Transport position
(325HE4)
Once the work has been completed fold the cutting unit back
against the shaft to simplify transport and storage of the
hedge trimmer.
1 Turn off the engine.
2 Fit the transport guard to the cutting attachment.
3 Loosen the knob on the shaft (clockwise).
4 Grip the handle on the cutting unit and angle the cutting
unit upwards. At an angle of 90 degrees there is a stop
position. To pass the stop position, pull out the lock button.
5 Fold down the cutting unit against the shaft.
6 Turn the knob (anti-clockwise).
CAUTION! When the stop position has been passed the
blades are blocked, do not try to cut with the cutting unit in this
position.
!
WARNING! Do not hold the cutting head
when you adjust the angle. The blades are
sharp and you could easily cut yourself.