Home Automation II - Manual (Page 26)

Page 18
OmniPro II Modules / Output
Unit Numbers Unit Numbers
193 - 208
X-10 modules 1 - 16, House Code X+12
209 - 224 X-10 modules 1 - 16, House Code X+13
(193 - 223) ALC addresses 1-31, Module 2 - Branch 1 *
225 - 240
X-10 modules 1 - 16, House Code X+14
241 - 256 X-10 modules 1 - 16, House Code X+15
(225 - 255) ALC addresses 1-31, Module 2 - Branch 2 *
257 - 272
Outputs 1-16, 1st Expansion Enclosure *
273 - 288
Outputs 1-16, 2nd Expansion Enclosure *
289 - 304
Outputs 1-16, 3rd Expansion Enclosure *
305 - 320
Outputs 1-16, 4th Expansion Enclosure *
321 - 336
Outputs 1-16, 5th Expansion Enclosure *
337 - 352
Outputs 1-16, 6th Expansion Enclosure *
353 - 368
Outputs 1-16, 7th Expansion Enclosure *
369 - 384
Outputs 1-16, 8th Expansion Enclosure *
385 - 392
Voltage Outputs (1-8), Fully Configurable
393 - 511
Internal Flags
Notes:
"X" Represents the House Code setting on the OmniPro II.
"*" If
used.
Scrolling Through Names
The OmniPro II stores names for Units, Zones, Buttons, Codes, Temperatures, and Messages so that you don't have to remember
that "UNIT 5" is the "DEN LIGHT" and "ZONE 1" is the "FRONT DOOR". In general, any time you enter a unit, zone, button,
code, temperature, or message number, you can press the down arrow key to display its name, then use the up and down arrow
keys to scroll through the list of other names. This is true when entering commands and programming on the console.