HONDA BC4050 - Manual (Page 20)

OPERATION BAGGER CART
I
Removing the Cover Assembly to Haul Other Loads
If the cart will not be used for bagging grass, you
can easily remove the cover and dump cloth to use
the
cart for hauling other loads. No tools are
needed.
1.
2.
3.
4.
5.
6.
Unhook and remove the middle chute (see
page 13).
Unhook the rubber strap from the rear of the
cart, and open the cover.
Pull out the strap that attaches the cover to
the top of the support tube.
Unhook the elastic loops from the bolts at the
front corners of the frame bed.
Remove the circle clips and washers from the
ends of the frame rod.
Pull the frame rod out of the support tube, and
remove the cover assembly.
Put the washers and circle clips on the frame
rod again, after removing the cover assembly.
This will help to prevent losing the hardware.
Remove the circle clips from the dump cloth
rod, then remove the rod from the frame bed,
and remove the dump cloth assembly.
Put the circle clips on the rod again, after
removing the dump cloth, to prevent loss.
Installing the Cover Assembly
Install the dump cloth and cover assembly in
the reverse of removal.
SUPPORT TUBE
DUMP CLOTH
Page 14