Hitachi 51G500S - Manual (Page 17)

17
FIRST
TIME
USE
CONNECTING EXTERNAL VIDEO SOURCES
CONNECTING AN S-VIDEO SOURCE TO INPUT 3, 4 AND 5
1.
Connect the cable from the S-VIDEO OUT of the VCR or the laserdisc player to the INPUT (S-VIDEO) jack, as shown on the TV
set below.
2. Connect the cable from the AUDIO OUT R of the VCR or the laserdisc player to the INPUT (AUDIO/R) jack.
3. Connect the cable from the AUDIO OUT L of the VCR or the laserdisc player to the INPUT (AUDIO/L) jack.
4. Press the VID4 button to view the program from the VCR or laserdisc player. The VIDEO label disappears automatically
after approximately four seconds.
5. Press the ANT button to return to the previous channel.
NOTES: 1. Completely insert the connection cord plugs when connecting to rear panel jacks. The picture and sound that is
played back will be abnormal if the connection is loose.
2. A single VCR can be used for VCR #1 and VCR #2, but note that a VCR cannot record its own video or line
output. (INPUT: 3 in example on page 11) Refer to your VCR operating guide for more information on line
input-output connections.
P
B
P
R
P
B
P
R
TO
CONVERTER
Y
R (MONO)/L
S-VIDEO
S-VIDEO
Y/VIDEO
R (MONO)/L
R (MONO)/L VIDEO
VIDEO
R L VIDEO
INPUT 1
INPUT 2
INPUT 3
INPUT 4
AUDIO
AUDIO
AUDIO
AUDIO
TO HI-FI
VCR
OUTPUT
R L V
S-VIDEO
S-VIDEO R (MONO)/L
INPUT 4
MONITOR
OUT
ANT A
ANT B
L
R
DVI-HDTV