Hitachi 37LD8800TA - Manual (Page 46)

45
FUNCTION (continued)
Photo Input Function
With this Photo Input function, you can enjoy watching Photos from such devices as
Digital Still Camera and SD card on monitor along with useful features such as Slide
Show with Background Music and Movie picture.
Operating the Photo Input
1. Before operating this function, make sure to turn the power OFF /Standby.
2. Prepare the DSC (Digital Still Camera) / USB card reader/ SD card or MMC as follows.
Digital Still Camera : Set up with reference to the content about
“connecting to PC” in the user manual of DSC.
USB Card Reader : Insert only one memory card.
SD Card / MMC : Ensure the card is inserted in the correct direction as
indicated near the slot.
3. Connect the USB cable to the input terminal as shown (Right side), or insert the
SD card /MMC into the slot (Left side).
4. Turn ON the TV after the USB cable is connected or the SD card / MMC is inserted.
5. Press button on the remote control to activate Photo Input mode.
(Then, turn ON the DSC. Refer to the user manual of your DSC for the timing.)
6. Each time button is pressed, you can switch the mode as follows.
Photo Movie Normal Screen
Rear Panel (Left side and Right side)
NOTE
Do not insert SD Card/MMC and USB cable at the same time.
Do not insert anything other than SD Card/MMC into the slot. It could cause malfuction or damage to the slot.
OK
P
P
SD MEMORY
CARD
PUSH-EJECT
PH35814
SD Card/MMC
Left Side
Digital Camera
USB Card Reader
USB cable
INPUT(A
V 5)
R
L/MONO
AUDIO
VIDEO
S-VIDEO
PH35826
Right Side