Hitachi 37LD8800TA - Manual (Page 18)

17
CONNECTION (continued)
Connecting Procedure (continued)
4. Connecting the plug into the wall socket
Connect the Power Cord after completing all other connections.
(The type of plug is different from this drawing for some countries.)
CAUTION
Use only the Power Cord provided.
Do not use a power supply voltage other than that indicated(AC100-240V, 50/60Hz). It may cause fi re or electric shock.
For the LCD panel, a three-core power cord with a ground terminal is used for effi ciency protection. Always be sure to
connect the Power Cord to a three-pronged grounded outlet and make sure that the cord is properly grounded. If you
use a power source converter plug, use an outlet with a ground terminal and screw down the ground line.
Ensure that both ends of power cord are easily accessible.
If you have to change the power cord, please use the certifi ed power cord that meets your region’s safety standard.
Information
How to secure the cables.
After connecting all of the cables to the terminals, secure them with the band.
When you secure the cables, please be careful not to tighten too much.
How to fasten the band:
To tighten
To loosen
Pull the band in the
direction of the arrow.
Loosen the band by
pushing the knob in the
direction of the arrow.
Knob
With long band
SUB
WOOFER
Licensed by BBE Sound, Inc. under USP5510752 and 5736897.
BBE and BBE symbol are registered trademarks of BBE Sound, Inc.
WOW, SRS and symbol are trademarks of SRS Labs, Inc.
SERVICE USE ONLY
INPUT(RGB)
ANALOG RGB
INPUT(HDMI)
PC
AUDIO
AUDIO
A C
INPUT
(AV1)
INPUT
(AV2)
INPUT
(AV3)
INPUT
(AV4)
ANT
OUTPUT
AUDIO AUDIO AUDIO AUDIO AUDIO
L MONO
C
L MONO
C
L MONO
C
L L MONO
C
R R R R R
VIDEO VIDEO VIDEO
P B
P R
P B
P R
Y/VIDEO Y/VIDEO
S-VIDEO
POWER SWIVEL
HDMI2
HDMI1