Hasselblad 949 - Manual (Page 32)

Preparing the Slide Feeder
for Storage or Transport
To prepare the Feeder for storage or transportation:
Detach the Feeder using the software-guided procedure given
“Unmounting the Slide Feeder” on page 15. Note that the Feeder must
be in its “home” position in order to fit into the box.
Retrieve the box in which your Feeder was originally delivered. This
box is made of sturdy cardboard and includes a foam lining custom
cut to hold the Feeder safely and securely.
Lay the box down on the floor or on a table.
Open the box, remove the top slab of foam and set it aside.
Align the Feeder so that it will fit into the cut foam, with the back of
the Feeder facing downwards.
Lower the Feeder into the box.
Replace the top slab and close the box.
The Feeder is now prepared for storage or shipping. If you will be storing
the box in any position other than lying down, then use packaging tape
to secure the flaps.
If you are planning to ship the feeder, be extra careful to ensure that the
flaps are securely taped shut. We recommend that you furthermore wrap
the box in strong paper before shipping.
If you need to return the Feeder to Hasselblad for repair, it must be in its
original box. Hasselblad will not accept shipment if the Feeder is shipped
in anything other than its original box.
1.
2.
3.
4.
5.
6.
7.