Hasselblad 949 User Manual

Page 23

Instead of using the standard preview/scan workflow in FlexColor,

click on the

button to open the

Scan 3f

window.

Make the various 3f settings as described in the FlexColor User’s

Guide. Note the following:

Use the

Destination

setting to select a parent folder in which to

save your 3f files. If you would like to create a new sub-folder for

each batch, mark the

Add job folder

check box; then, each time

you begin a new 3f batch scan, FlexColor will create a new sub-

folder below the

Destination

folder and save the new scans there.

Either way, the contents of the most recently used folder will be

displayed in the FlexColor

Thumbnails

window immediately after

the batch is finished.

All images will have a name based on the value entered in the

Image Name

field, plus a unique number.

Usually, it is easiest use the

Crop

settings to automatically remove

the parts of the scan that are covered by the slide mounting.

If you have both negative and positive originals in your batch,

you should set the

Film Type

to “Auto Detection”. This will cause

•