Hawke Sport Optics 1-4x20 Vantage IR Riflescope (Turkey Dot IR Reticle) - Manual (Page 9)

9
Final sighting-in of your rifle should be carried out with live ammunition, based on your preferred
target distance.
Warning: If a bore sighting collimator or any other bore obstructing device was used, it must be
removed before zeroing with live ammunition. An obstruction can cause serious damage to the gun
and possible injury to yourself and others nearby.
Sighting in should be at the distance that you are normally going to shoot. The parallax should be
set to this distance during the sighting in process. Set variable power scopes to highest power then
from a steady rest position fire three rounds at a target. Observe point of impact on the target and
adjust windage and elevation turrets as needed to correct aim. Repeat until point of aim and point
of impact are the same. When you are happy with the zero, replace the turret covers.