NEC 40,000-Lumen 4K Laser Installation Projector User Manual
Page 137
120
5. Using On-Screen Menu
DATE AND TIME SETTINGS
You can set the current time, month, date, and year.
NOTE: The projector has a built-in clock. The clock will keep working for about a month after the main power is turned off. If the
main power is off for a month or more, the built-in clock will cease. If the built-in clock ceases, set the date and time again. The
built-in clock will not cease while in the standby mode. In order to activate the built-in clock continuously even when the projector
is not used, leave it in the standby state not plugging off the power cable.
TIME ZONE SETTINGS .............. Select your time zone.
DATE AND TIME SETTINGS ...... Set your current date (MM/DD/YYYY) and time (HH:MM).
INTERNET TIME SERVER: If you place a check mark, the projector’s built-in clock will be syn-
chronized with an Internet time server in every 24 hours and at the time of projector’s startup.
UPDATE: Synchronizes the projector’s built-in clock immediately. The UPDATE button is not
available unless the INTERNET TIME SERVER check box is turned on.
SUMMER TIME SETTINGS ....... If you place a check mark, the clock for daylight saving will be enabled.
Disabling the Cabinet Buttons [CONTROL PANEL LOCK]
This option turns on or off the CONTROL PANEL LOCK function.
NOTE:
• How to cancel the [CONTROL PANEL LOCK]
When the [CONTROL PANEL LOCK] is set to [ON], press the KEY LOCK button on the cabinet for 1 second or longer to cancel
the [CONTROL PANEL LOCK] setting.
TIP:
• When the [CONTROL PANEL LOCK] is turned on, a key lock icon [ ] will be displayed at the bottom right of the menu.
• This CONTROL PANEL LOCK does not affect the remote control functions.
[NOTIFICATION SETTINGS]
This setting is to enable/disable the notification by the buzzer and rear LED (Light status indicator/System status
indicator).
REAR LED
OFF
[REAR LED] is deactivated.
ON
The [REAR LED] informs you of the unit’s status just like the status indicator.
BUZZER
OFF
The buzzer goes off
ON
The buzzer stops.
Enabling Security [SECURITY]
This feature turns on or off the SECURITY function.
Unless the correct keyword is entered, the projector cannot project an image. (
→
NOTE: Your setting will not be affected even when [RESET] is done from the menu.
Selecting Communication Speed [COMMUNICATION SPEED]
This feature sets the communication speed for the PC Control port (D-Sub 9P). Make sure to set the appropriate
speed for the device to connect.
NOTE:
• Select [38400bps] or less when using our utility software “NaViSet Administrator 2”.
• Your selected communication speed will not be affected even when [RESET] is done from the menu.