Planar Systems PZD2410 23.8" Monitor - Manual (Page 21)

19
TECHNICAL SUPPORT (FAQ)
Problem & Question Possible Solution
Power LED is not on * Check if the Power Switch is in the ON position.
* Power Cord should be connected.
No Plug & Play * Check if the PC system is Plug & Play compatible.
* Check if the Video Card is Plug & Play compatible.
Picture is fuzzy * Adjust the Contrast and Brightness Controls.
Picture bounces or a wave pattern is
present in the picture
* Move electrical devices that may cause electrical
interference.
The power LED is ON (Blue) but there’s
no video or no picture.
* Computer Power Switch should be in the ON
position.
* Computer Video Card should be snugly seated in
its slot.
* Make sure monitor’s video cable is properly
connected to the computer.
* Inspect monitor’s video cable and make sure
none of the pins are bent.
* Make sure computer is operational by hitting the
CAPS LOCK key on the keyboard while observing
the CAPS LOCK LED. The LED should either turn
ON or OFF after hitting the CAPS LOCK key.
* If connected to USB Type C, make sure USB
standby is set to On.
Missing one of the primary colors
(RED, GREEN, or BLUE)
* Inspect the monitor’s video cable and make sure
that none of the pins are bent.
Picture has color defects
(white does not look white)
* Adjust RGB color or select color temperature.
Poor brightness or contrast * When the brightness of the screen lowers
after being used for a certain period and the
function of the display is affected, send it to our
authorized service center for repair.
No power for USB hub * Make Sure the USB cable is well connected to the
upstream.
* Make Sure USB standby is set to On.
Connected USB devices and Ethernet
speed is slow
* Change USB setting from USB2.0 to USB3.2