Planar Systems PZD2410 23.8" Monitor - Manual (Page 13)

11
Daisy Chain Connection
With USB Type-C/Displayport Multi-Stream Transport (MST) support, you can daisy chain
to another monitor. Connect one end of a DisplayPort/USB Type-C cable to the PZD2410
monitor and the other end to a computer. Next connect the Displayport output cable on the
PZD2410 monitor to the Displayport input of another monitor.
To clone or extend display. In OSD-->Extra-->DP Out-->Extend/Clone.
DP In
PZD2410
DP Out DP In DP Out
PXV2410 or PXN2410
Figure 3
For a consistent look, Planar recommends the PXV2410 or PXN2410.
Note: Make sure your PC supports Displayport MST transport.
Resolution
When "DP out" is in "Clone" state, the daisy chain is in SST mode. USB is switched to USB 3.2
data rate. Display resolution is 1920 x 1080 @ 60Hz.
When "DP out" is in "Extend" state, the daisy chain of PZD2410 is in MST mode. USB is
swtiched to USB 2.0 data rate. The combined data of all displays in the daisy chain cannot
exceed the DisplayPort port limit of a single video source, nor can it exceed the capabilities
of the graphics card (for the DisplayPort 1.2 port, the limit is 17.28 Gbit/s). Depending on
the capacity of the PC and graphics card, about 3~4 units can be connected in series for
1920x1080 @60Hz resolution monitors.
In "Extend" mode, the network speed drops to 10/100Base.