Vizio M-Series Quantum Q7-J03 70" Class HDR 4K UHD Smart Quantum Dot LED TV - Manual (Page 17)

11
3
Adjusting the Color Tuner Settings
The Color Tuner settings allow you to adjust the color management system, 20 point
white balance, turn color channels off for testing, and display SMPTE, flat, ramp, and
uniformity analyzer test patterns.
To access the color tuner table:
Menu > Picture > Advanced Picture > Color Calibration > Color
Tuner
WARNING: The Color Tuner, 20 Point White Balance, and
test patterns allow technicians to manually calibrate the TV.
Calibration requires specialized training, an input with precisely
set colors, and a specialized light meter.
To turn color channels off and on:
1. Use the Navigation buttons on the remote to highlight Red , Green , or Blue .
2. Press the OK button to turn the color channel off or on. An X appears over a
color channel that has been turned off.
3. Only two color channels can be turned off at the same time.
TIP: Any changes made affect the color temperature setting.
Select the preferred color temperature setting first. See Adjusting
the Color Temperature on page 9.
To adjust the color management system settings:
1. Use the Navigation buttons on the remote to highlight the Hue, Saturation,
Brightness, Offset, or Gain of the color you wish to adjust. Press the OK button.
2. Use the Left/Right Navigation buttons to adjust the value. When you are
finished press the OK button to save the setting.
Color Tuner
Red Green Blue Cyan Magenta Yellow
Hue 0 0 0 0 25 -14
Saturation -1 5 -4 0 -2 0
Brightness -24 0 -22 0 0 0
To show or hide the SMPTE Test Pattern:
Menu > Picture > Advanced Picture > Color Calibration > Color
Tuner > SMPTE Test Pattern
SMPT Test Pattern
Off
1. Use the Navigation buttons on the remote to highlight Off. Use the Left/Right
Navigation buttons to select On to show the SMPTE Pattern.
— — or
2. To hide the SMPTE Test Pattern, use the Left/Right Navigation buttons to
select Off.
To show or hide the Flat Test Pattern:
Menu > Picture > Advanced Picture > Color Calibration > Color
Tuner > Flat Test Pattern
Flat Test Pattern
Off
1. Use the Navigation buttons on the remote to highlight Off. Use the Left/Right
Navigation buttons to select the percentage brightness for the flat test pattern.
Selecting a percentage immediately shows the flat pattern at that brightness.
—or—
2. To disable the Flat Test Pattern, use the Left/Right Navigation buttons to
select Off.