GRAM FS 441862 N (v)/1 User Manual
Page 31
EN - 29 -
Installation warnings
Before using your freezer for the first time, please pay attention to the following points:
•
The operating voltage for your freezer is 220-240 V at 50Hz.
•
The plug must be accessible after installation.
• Your freezer may have an odour when it is operated for the first time. This is normal and
the odour will fade when your freezer starts to cool.
•
Before connecting your freezer, ensure that the information on the data plate (voltage
and connected load) matches that of the mains electricity supply. If in doubt, consult a
qualified electrician.
• Insert the plug into a socket with an efficient ground connection. If the socket has no
ground contact or the plug does not match, we recommend you consult a qualified
electrician for assistance.
•
The appliance must be connected with a properly installed fused socket. The power
supply (AC) and voltage at the operating point must match with the details on the name
plate of the appliance (the name plate is located on the inside left of the appliance).
•
We do not accept responsibility for any damages that occur due to
ungrounded usage.
• Place your freezer where it will not be exposed to direct sunlight.
• Your freezer must never be used outdoors or exposed to rain.
•
Your appliance must be at least 50 cm away from stoves, gas ovens and
heater cores, and at least 5 cm away from electrical ovens.
• If your freezer is placed next to a deep freezer, there must be at least 2 cm between
them to prevent humidity forming on the outer surface.
• Do not cover the body or top of freezer with lace. This will affect the performance of your
freezer.
•
Clearance of at least 150 mm is required at the top of your appliance. Do not place
anything on top of your appliance.
•
Do not place heavy items on the appliance.
•
Clean the appliance thoroughly before use (see Cleaning and Maintenance).
•
Before using your freezer, wipe all parts with a solution of warm water and a teaspoon of
sodium bicarbonate. Then, rinse with clean water and dry. Return all parts to the freezer
after cleaning.
•
Use the adjustable front legs to make sure your appliance is level and stable. You can
adjust the legs by turning them in either direction. This must be done before placing food
in the appliance.
•
Install the two plastic distance guides (the parts on the black vanes -condenser- at the
rear) by turning it 90° (as shown in the figure) to prevent the condenser
from touching the wall.
• The distance between the appliance and back wall must be a maximum
of 75 mm.