İhlas Aura Roboclean - Manual (Page 23)

23
- Only use CR123A, 3V type batteries.
- The battery in this appliance is not
rechargeable. Do not try to recharge.
- Rechargeable batteries are to be removed
from the appliance before being charged.
- The battery is to be inserted with the
correct polarity.
- Exhausted battery is to be removed from
the appliance and safely disposed of.
- If the appliance is to be stored unused for
a long period, the battery should be removed.
- The supply terminals are not to be short-
circuited.
- Keep the appliance and the battery
away from children.
- The low battery indicator (
) will
be shown on the remote control display
when the battery has run out.
- You can procure a new battery from an
Authorized Service Provider.
Slide the lid in direction of the
arrow to open the battery slot
In a double-insulated appliances, two systems of insulation
are provided instead of grounding. No grounding means is
provided on a double-insulated appliance, nor should a
means for grounding be added to the appliance. Servicing
a double-insulated appliance requires extreme care and knowledge of the system, and should be done only by
qualified Roboclean service personal. Replacement parts
for a double-insulated appliance must be identical to the
parts they replace.
REPLACEMENT OF THE REMOTE CONTROL BATTERY
SERVICING OF DOUBLE - INSULATED APPLIANCE
REPLACEMENT OF THE POLLEN
FILTER
Replace the pollen filter on your appliance with the auxiliary
pollen filter supplied with the product after using it for 5-6
months. To change the filter, pull the tab on the filter cover
and remove the cover. Replace the old filter with the new one
and close the filter cover. You should replace this new pollen
filter on average once a year.
! Never operate your appliance without the separator.
Always remove and clean the separator every two to
three uses. Remove the separator cleaning brush from
its slot on the body. Remove the separator nut with the
wrench on the brush. Remove the separator and clean
the inside and outside of the separator with soapy
water using the separator cleaning brush. Put in back
in place it by putting it on its housing after drying. Place
the nut on the separator and tighten with the wrench.
Do not forget to re-install the separator brush after you
have completed this operation.
CLEANING OF THE SEPERATOR
! Never operate your appliance without the pollen filter.