İhlas Aura Roboclean - Manual (Page 15)

15
11 2 4
3
! WARNING
This hose includes electrical connections;
• It should not be used for sucking up water or other liquids.
• It should not be immersed in water for cleaning.
• Hose should be checked regularly and should not be used if it is damaged.
FILLING THE BASIN WITH WATER
CONNECTING THE VACUUM HOSE
TO THE BODY
1 - Release the latches on both sides of the appliance.
Separate the main body from the water basin.
2 - Fill the dirty water basin with clean water up to the top of the measuring post in
its center. The water amount to be filled isabout 1.8 L. (Please ensure that the water
does not exceed the height of the measuring post).
! Do not operate the appliance without water.
3 - Put the water-filled basin, into the clean water basin and place it on the dolly.
4 - Secure the body to the dolly with the locking latches.
5- Lift the outlet cover on the body upwards as shown in the figure.
6 - Press the hose adaptor on the end of the vacuum hose into latches on the sides,
and secure it on the body by pushing it so that the plugs and locks engage each
other. Ensure that the tabs are locked by pulling the hose slightly.
7 - To separate the vacuum hose from the body, press the clamps on both sides of
the hose adaptor and pull the hose towards you.