H3C Technologies H3C SecPath U200-A U200-M U200-S - Manual (Page 33)

24
Connecting the AC power supply to a power strip
with lightning protection
CAUTION:
Make sure the PE terminal of the power socket has been securely grounded.
If part of the AC power line is routed outdoors, use a power strip with lightning protection to connect the
AC power cord of the UTM device to the AC power line to protect the UTM device from being damaged
by lightning strikes.
You can attach the power strip to the rack, workbench, or wall of equipment room.
After you connect the AC power cord from the UTM device to a socket on the power strip, verify that the
green RUN LED on the strip is on and the red LED is off.
If the red LED is on, use a multimeter to check the polarity of the wires in the power socket for wrong
connections. If the zero wire (left) and the live wire (right) are correctly connected, check for missing
grounding connection.
Figure 27 Power strip with lightning protection
(1) Operating LED (green) On means the circuit is operating properly.
Off means the circuit is damaged.
(2) Grounding/pole detection
LED (red) On indicates a wrong wire connection (the wire is not grounded or the
live line and null line are reversely connected), and you need to check the
power supply line.
(3) Power switch
(4) IEC standard socket
It is used to connect to the power supply in the equipment room through a
power cord.
(5) Overload automatic protector The protector automatically opens the electric circuit when the current
exceeds the threshold and closes the electric circuit when the current
drops below the threshold.
(6) Multifunctional socket It is used to connect the power supply of the UTM device.
N N N N L L L L