ZeeVee ZvCli User Manual - Manual (Page 9)

Zv‐Cli v1_3 www.zeevee.com Page 9 of 32
and ends with ‘set rf‐output on”. Turning the RF output off is a pre‐requisite for several commands (like ‘set rf‐
channel’), and turning it back on is required for the ZvBox to output a channel.
Syntax
show config
Example:
ZvCli$ show config
# Disable RF output to be safe while configuring other items
set rf‐output off
set audio‐for‐component analog
set audio‐for‐vga analog
set cable‐plan standard
set custom‐idle‐screen “”
set custom‐watermark “”
set led‐brightness high
set mpeg2 audio‐delay 4
set mpeg2 dc‐coefficient‐size 10‐bit
set mpeg2 output‐data‐rate normal
set mpeg2 program video1 eit‐name "Video Over COAX"
set mpeg2 program video1 eit‐tv‐rating TV‐G
set mpeg2 program video1 hdtv‐channel 2.1
set mpeg2 program video1 long‐channel‐name "Welcome To ZeeVee ZvCast"
set mpeg2 program video1 program‐number 1
set mpeg2 program video1 short‐channel‐name "ZvCast"
set mpeg2 starting‐pid‐number 256
set output‐frame‐rate‐for‐720p 30fps
set rf‐channel 2
set rf‐power 5‐highest
set select‐button enabled
set vga‐edid‐underscan‐resolution‐1080 1808x1017
set vga‐edid‐underscan‐resolution‐720 1208x679
set vga‐output‐resolution auto
set video‐source component
set watermark‐visual on
set zvbox‐name "unnamed"
# Following is the configured rf‐output value
set rf‐output on
ZvCli$
Analyze Current Configuration and Status
ZvCli is able to look at ZvBox’s current configuration and status, and will report warnings when things look ‘odd’.
The following items are checked.