ZeeVee ZvCli User Manual - Manual (Page 19)

Zv‐Cli v1_3 www.zeevee.com Page 19 of 32
their analog equivalents, but still found by the user on familiar channel numbers. The HDTV channel is
sometimes referred to as a Logical or Virtual channel.
Syntax
set mpeg2 program {video1} hdtv‐channel <0..1023>. <0..1023> factory default: 2.1
Example:
ZvCli$ set mpeg2 program video1 hdtv‐channel 53.1
Success
Sets the virtual channel to 53.1, which can be tuned in at the HDTV by entering 53.1. Note – Some HDTVs use a
dash instead of a dot. Some TVs will also find your new channel if you just enter 53.
Note ‐ We recommend matching the RF channel and the number left of the decimal point. We also recommend
using 1 to the right of the decimal. Doing so helps most HDTVs receive your new channel without requiring a
full channel scan at each TV. This methodology also seems to reduce the likelihood of conflict, as most cable
operators seem to follow this methodology (at least for the left number)
Note ‐ since there are no rules regarding the usage of HDTV channel numbers, in rare cases, you may have a
conflict. For example, some other channel may be broadcasting on RF channel 53, but declare its HDTV channel
to be 5.1. There will be a conflict if you try to use 5.1 as well. The only way to know for certain if there is a
conflict is to perform a full channel scan at the HDTV, and check to see if there are other HDTV channels that
conflict with a number that you intend to use.
Note – Changing HDTV channel numbers while still broadcasting can sometimes confuse any connected HDTVs.
We require turning off the broadcast (set rf‐output off) before making these changes. You may also want to
perform a full channel scan at each HDTV after your channel changes are complete, which will clear any memory
of old channel locations.
Set Event Information Table (EIT) Name (HDTV Program Guide Entry)
The event information table name is used by some HDTVs that show schedules of upcoming programs. ZvBox is
always sending the same “program” – this command allows you to populate a name into that guide. The guide
always contains 4 entries, 3 hours long.
Syntax
set mpeg2 program {video1} eit‐name “name” name <=132 chars
factory default: “Video Over COAX”
Example:
ZvCli$ set mpeg2 program video1 eit‐name “ New Guide Info ”
Success