NavCom SF-2050 Rev.D - Manual (Page 52)

SF-2050 User Guide - Rev. D
The Event Input can be triggered on the Falling, or
Rising edge of the input pulse; Figure D2 shows the PPS
& Event Latch window. After configuring the specifics
of the input pulse, the Event Latch message (0xB4)
must be enabled in the NCT 2000 Message Output list.
However the Message Rate for the 0xB4 must be set to
“On Trigger”. The “On Trigger” message rate can be
located by Right- Clicking on the Rate area adjacent to
the B4 Message ID, and following the menus as seen in
Figure D3. The Event Latch Message 0xB4 will only be
output when the chosen pulse edge of the incoming
event is sensed by the receiver.
Figure D2: PPS & Event Latch Configuration
Figure D3: Event Latch Output Rate Configuration
D-50