NavCom SF-2050 Rev.D - Manual (Page 29)

SF-2050 User Guide - Rev. D
Communication Ports
Connect the supplied LEMO 7-Pin end of the NavCom
serial cable (NavCom P/N 94-310059-3006) to COM 2
(factory default control port) connector of the SF-2050.
Connect the
DB9S end to your controlling device. Note
that some devices may require an additional adaptor.
‡
By factory default COM 2 is designated as the control
port for the SF-2050. COM 1 can be designated as the
control port by using the appropriate NavCom
proprietary commands . Although some output data
types cannot output on the controlling port.
Figure 8: Communication Port Connections
3-27