beautypg.com

Marantz DV-17 User Manual

Foreword, Warnings, Ce marking

background image

1

ENGLISH

FOREWORD

This section must be read carefully before any connection is
made to the mains supply.

WARNINGS

Do not expose the equipment to rain or moisture.

Do not remove the cover from the equipment.

Do not insert anything into the equipment through the
ventilation holes.

Do not handle the mains lead with wet hands.

Make a space of about 0.1 meter around the unit.

CE marking

This product is in conformity with the EMC
directive and low-voltage directive.

EQUIPMENT MAINS WORKING SETTING

Your Marantz product complies with the household power and
safety requirements in your area.

IMPORTANT: (FOR UK version only)

This apparatus is fitted with an approved moulded 13 Amp plug.
To change a fuse in this type of plug proceed as follows:

1. Remove fuse cover and fuse.

2. Fix new fuse which should be a BS1362 5A, A.S.T.A. or BSI

approved type.

3. Refit the fuse cover.

If the fitted plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place.
If the mains plug contains a fuse, this should have a value of 5A.
If a plug without a fuse is used, the fuse at the distribution board
should not be greater than 5A.

NOTE : The severed plug must be destroyed to avoid a possible

shock hazard should it be inserted into a 13A socket
elsewhere.

HOW TO CONNECT A PLUG

The wires in the mains lead are coloured in accordance with the
following code:
BLUE—”NEUTRAL” (“N”)
BROWN—”LIVE” (“L”)

1. The BLUE wire must be connected to the terminal which is

marked with the letter “N” or coloured BLACK.

2. The BROWN wire must be connected to the terminal which is

marked with the letter “L” or coloured RED.

3. Do not connect either wires to the earth terminal in the plug

which is marked by the letter “E” or by the safety earth symbol

or coloured green or green-and-yellow.

Before replacing the plug cover, make certain that the cord grip
is clamped over the sheath of the lead — not simply over the two
wires.

PRECAUTIONS

The following precautions should be taken when operating the
equipment.

GENERAL PRECAUTIONS

When installing the equipment ensure that:

– the ventilation holes are not covered.

– air is allowed to circulate freely around the equipment.

– it is placed on a vibration-free surface.

– it will not be exposed to excessive heat, cold, moisture or dust.

– it will not be exposed to direct sunlight.

– it will not be exposed to electrostatic discharges.

In addition, never place heavy objects on the equipment.

If a foreign object or water does enter the equipment, contact
your nearest dealer or service center.

Do not pull out the plug by pulling on the mains lead; grasp the
plug.

It is advisable when leaving the house, or during a thunderstorm,
to disconnect the equipment from the mains supply.