Marantz SA-14S1N - Manual (Page 9)

2
Connections
Playback
Settings
Tips
Appendix
ENGLISH
Preparation
Accessories
Check that the following parts are supplied with the product.
q Owner’s manual ........................................................... 1
w Power cord ................................................................... 1
e Audio cable .................................................................. 1
r Remote control cable ................................................... 1
t Remote control (RC001PMSA) .................................... 1
y R03/AAA batteries ....................................................... 2
w e
r t
About the remote control
Inserting the batteries
q Remove the rear cover of
the remote control.
w Set two R03/AAA batteries
in the battery compartment
in the indicated direction.
e Put the rear cover back on.
NOTE
• Replace the batteries with new ones if the unit does not
operate even when the remote control is operated close to
the unit.
• The supplied batteries are only for verifying operation.
• Insert the batteries in the proper direction, following the q
and w marks in the battery compartment.
• To prevent damage or leakage of battery fluid:
• Do not use a new battery with an old one.
• Do not use two different types of batteries.
• Do not attempt to charge dry batteries.
• Do not short-circuit, disassemble, heat or dispose of
batteries in a fire.
• Do not keep the battery in a place exposed to direct sunlight
or in places with extremely high temperatures, such as near
a heater.
• If the battery fluid leaks, carefully wipe the fluid off the inside
of the battery compartment and insert new batteries.
• Remove the batteries from the remote control if it will not be
used for a long time.
• Dispose of batteries in accordance with local regulations on
battery disposal.
• The remote control unit may function improperly if
rechargeable batteries are used.
Operating range of the remote control
Operate the remote control while pointing it at the remote
sensor.
Approx. 7 m
30° 30°
NOTE
The unit may function improperly or the remote control may
not operate if the remote control sensor is exposed to direct
sunlight or strong artificial light from a fluorescent or infrared
light.