Marantz SA-14S1N - Manual (Page 28)

21
ENGLISH
y Click “Install” on the installation start dialog.
• The installtion starts. Do not perform any operation
on the computer until the installation is completed.
y
u In the Windows security dialog, select “Always trust
software from DandM Holdings Inc.”.
i Click “Install”.
i u
o When the installation is completed, click “Finish”.
o
Using as a D/A converter
5 With the unit power off, connect the unit and
computer using a USB cable (sold separately).
• For the connection procedure, refer to the “Connecting
a PC or Mac” (vpage 11) section.
6
Press X on this unit.
• When the unit power is turned on, the computer
automatically finds and connects to the unit.
7 Press DISC/INPUT to change the input source
to “USB-DAC” (vpage 13).
8 Checking the installed driver
q Click “Start” and click “Control Panel” on the
computer.
• The control panel setting list is displayed.
w Click “Sound”.
• The sound menu window is displayed.
e Check that there is a checkmark next to “Default
Device” under “Marantz USB Audio” in “Speakers”
of the “Playback” tab.
• When there is a checkmark for a different device,
click “Marantz USB Audio” and “Set Default”.
9 Checking audio output
Outputs a TEST signal from the computer and checks
the audio output from the USB-DAC function.
q Select “Speakers” and click “Properties”.
• The Speakers Properties window is displayed.
q
w Click “Advanced”.
• Select the sampling rate and bit rate to be applied to
the D/A converter, and click “Apply”.
e Click “Test”.
• If the audio is output from the this unit, the setup is
completed.
w
e