Lumens Technology DC-W50 User Manual
Page 29
English - 28
cannot be
displayed when
the setting is
updated
Method 2: Please follow the steps of
6.1.1 Manual
connection
for reconnection
Method 3: Please press and hold the DC-W50 [Reset]
button for 5 seconds. After restarting, please follow the
steps of
Chapter 6 Start Using
for reconnection.
If the problem still occurs, please contact your distributor.
9 The
corresponding
DC-W50 cannot
be identified
when two or
more DC-W50s
are connected
Please follow the steps of
6.1.3 Change the SSID
to
modify the SSID.
10
If you forget the
password and
cannot log in the
administrator
webpage
Please press and hold the DC-W50 [Reset] button for 5
seconds and restore the factory default values.
11
What if the signal
is weaker?
1. Please
adjust
the
place
of DC-W50 to obtain better
connection quality.
2. Please go to the administrator webpage and set
DC-W50 at different channel frequencies so as to
avoid the interference of signal transmission.
12
The DC-W50
client cannot be
found when
using Ladibug
software
Please reset DC-W50 client (press the DC-W50 [Reset]
button for 5 seconds till restarting is completed), and reset
in accordance with the
8.3.2 DC-W50 client setting
, and
resume operation.
13
I cannot connect
with WPS after
modifying
DC-W50
encryption
settings
At present WPS only supports WPA/WPA2 encryption
mode of higher security level. Therefore, the encryption set
to WEP or off cannot support WPS. Please refer to
6.1.1
Manual connection
for how to connect without WPS.
14
Upload function
is not available
The upload function is not available because the computer
wireless network is connected to DC-W50, and not
connected with the Internet. Please refer to the following
solutions :
1. After completing the Ladibug operation, connect the
wireless network to the Internet again. Then the upload
function can be used
2. Use an additional network line to connect the computer
with the Internet. Then the upload function can be used
while you are operating the Ladibug