System troubleshooting troubleshooting – InSinkErator WX-300 User Manual
Page 18

19
PROBLEM
POSSIBLE CAUSE
SOLUTION
Waste Xpress stops unexpectedly.
•
Discharge chute misaligned.
•
Fuse blown or circuit breaker
tripped at power source.
•
Stop button on control center
has been pushed.
•
Reinstall discharge chute to ensure
proper fi t.
•
Replace fuse or reset circuit breaker.
•
Push start button on control center.
Water exits Waste Xpress
at front of cabinet.
•
Drain line has clog.
•
High water level.
•
Clear drain.
•
Add second waste outlet drain connect from
Waste Xpress cabinet to sewer connection
(recommended for trough applications).
Waste Xpress does not run,
but disposer and water run.
•
Contactor defective.
•
Auger motor defective.
•
Call service.
•
Call service.
No water spraying onto
auger screen.
•
Solenoid valve clogged.
•
Water turned off.
•
Solenoid valve defective.
•
Spray nozzles clogged.
•
Timer defective.
•
Timer not set properly.
•
Solenoid valve installed incorrectly.
•
Remove clog.
•
Turn on water.
•
Call service.
•
Replace nozzles.
•
Call service.
•
Call service.
•
Reinstall solenoid valve so arrow is pointing
in correct direction.
Water fl ows continuously before
controls are turned on.
•
Solenoid valve installed incorrectly.
•
Timer is not set properly.
•
Solenoid valve is defective.
•
Reinstall the water solenoid valve with the
arrow on the valve pointing in the direction
of the water fl ow.
•
Call service.
•
Replace solenoid valve.
Overload protector trips frequently.
•
Disposer is overloaded with
food waste.
•
Do not overload disposer with excessive
amounts of food waste.
SYSTEM TROUBLESHOOTING
Troubleshooting