BSS Audio BLU-50 Install Guide - Manual (Page 7)

1
Regulatory Information
An example of this equipment has been tested and found to comply with the following European and international
Standards for Electromagnetic Compatibility and Electrical Safety:
Radiated Emissions (EU):
EN55013 (2001+A1)
Immunity (EU): EN55020 (1998)
Electrical Safety (EU): IEC60065-01 + AMD1
Electrical Safety (USA): UL60065-06
Product Registration/Warranty
To register your product, please visit http://bssaudio�com/en-US/support/warranty_registration�
For warranty information, please visit http://bssaudio�com/en-US/support/warranty_policy�
Important User Information
Do not remove covers. No user serviceable parts inside, refer servicing to qualified service personnel. For continued
compliance with international EMC regulations, it is important that all cables be screened, and connected as
follows: Audio cable screens to their BLU-50 connector ground� Control cable screens to the ground screws
adjacent to the connector. Network cables should be of type Cat 5, fitted with a clip-on ferrite sleeve (STEWART
TYPE 28A2029-0A0) near the network socket end� This equipment must be earthed� It should not be necessary to
remove any protective earth or signal cable shield connections to prevent ground loops� Any such disconnections
are outside the recommended practice of BSS Audio, and will render the EMC or safety certificate void.
Mechanical Installation
The BLU-50 must be installed according to the guidelines laid out in this document� Damage caused to the BLU-50
resulting from a failure to follow these guidelines is not covered by the warranty�