BSS Audio BLU-50 Install Guide - Manual (Page 11)

5
Front Panel
Input/Output Channel Monitoring
Each channel in the input section has the following LED
indicators:
The output section has the same LEDs, without the 48V
LED indicators�
Clip
Indicates clipping in the analogue domain for each input or output channel� The LED will illuminate at +18�5dB�
Signal
The Signal LED will illuminate for each input or output channel when the signal reaches or exceeds the signal
threshold of -20dB�
Input channels have a third indicator:
48V
(Input channels only) Illuminates to indicate +48V phantom power has been activated for the relevant input
channel�
COM (Communications)
The COM LED turns green to indicate a normal linked condition� The COM LED
blinks green if data is being transferred on the Ethernet or RS232 port� The LED turns
yellow if a link is established but no IP address has been established�
STAT (Status)
The STAT LED turns green when a valid design file is loaded and running. The STAT
LED turns yellow when the design is paused� The STAT LED turns red when the
design is stopped�
ERR (Error)
The ERR LED is normally off� It turns red in the case of a critical or fatal error�
PWR (Power)
The PWR LED turns blue when the device is powered on� It blinks during locate
operations (both when pressing the locate button on the rear of the device and also
when locating the device from within the software)�