American Time Wireless Indoor Bell - Manual (Page 5)

© American Time
Wireless Bell
Installation Instructions
Wiring
Wiring of the Wireless Bell consists of three wires—Black-HOT; White-NEUTRAL;
Green-GROUND.
n Note: When wiring any high voltage device, follow all local and national electrical codes. A licensed electrician is required
for any high voltage wiring.
Wiring will be accessed from the opening in the bottom of the enclosure.
Setup
Once the Wireless Bell is wired and powered up, it may be tested or activated by using the MAN button on the system
controller or via the Circuit Tab of the Remote Connect web interface (using a SiteSync IQ system controller with the
Ethernet option and a computer with internet access).
See the SiteSync IQ Operation & Installation Manual for additional support information.
3