Operation, Wiring diagram, Use with sitesync iq – American Time Wired Tone Generator User Manual
Page 7: Multi tone generator, Contact information operation specifications, American time
7
© American Time
Multi Tone Generator
Contact
Information
Operation
Specifications
Operation
Use with SiteSync IQ
®
System Controllers
The tone generator can also be used in conjunction with the SiteSync IQ System Controller to schedule
the triggering of tones. This can be done by hardwiring the tone generator to the SiteSync IQ System
Controller or wirelessly through the SiteSync IQ transmitter.
The unit can be triggered by wiring the desired T1-T4 combinations to the NO terminal of one of the six
bell circuits located on the back of the SiteSync IQ system controller. The COM terminal of the system
controller bell circuit should then be connected to the C terminal (Tone Selection Common). The user
can now set up circuit events on the SiteSync IQ system controller which control when and how long
the desired tone is triggered off and on.
n
Note: See the SiteSync IQ Wireless Installation Manual before installation. Also, verify that the
system controller you have has the bell circuit option.
REAR OF SY
STEM C
ONTR
OLLER
COM
NO
NC
NC
COM
NO
NO
COM
NO
COM
COM
NO
NO
COM
NO
COM
NO
COM
CLOCK 1
CLOCK 2
BELL 1
BELL 2
BELL 3
BELL 4
BELL 5
BELL 6
GAIN
T1
T2
T3
T4
PA/AMP
IN
COM
Red (+)
Blk (-)
COM
COM
SPKR
SPKR
AUDIO IN
AUDIO OUT
(+)
(-)
12VDC
Multi-T
one Generator
(500 mA max)
1-800-328-8996 www
.atsclock.com
Wiring Diagram