Brennenstuhl Power Jet-Light 4 x 55 Watt IP54 spotlight 5m H07RN-F 3G1,5 4x4800lm Energy efficiency class A - Manual (Page 18)

14 GB
Safety Instructions / Bringing into use / Maintenance
workbench or working surface. Place the
product down on a non-abrasive surface only.
By doing this you will avoid damaging the
product.
O Never operate the product if it has a defective
lamp guard 2 . Replace the lamp guard 2 if
it is defective.
O Check the product regularly for damage.
O Always ensure that there is a minimum clear
distance of approx. 50 mm between all sides
of the product and any combustible material.
O Always ensure that the product stands in a
stable position.
Q
Bringing into use
q
Assembling / disassembling
the work light
WARnInG! Pull the mains plug out of the
mains socket before you carry out any task on the
device. Otherwise there is a danger to life!
note: To do this you will require a Phillips
screwdriver.
Follow these steps:
1. First place the work light down with its lamp
guard 2 at the bottom on the floor.
CAuTIOn! Place a soft cover or similar item
on the supporting surface first to avoid
scratching the lamp guard
2 .
2. Push the retainer 8 from below on to the work
light. Ensure that the two clips of the retainer 8
are seated in the recesses in the work light
(see Fig. A).
3. Now place the spacer 10 between the retainer
8 and the work light and screw the stud
bolts 9 in clockwise (see Fig. B).
4. Push the frame stirrup 1 on to both frame legs
4 . Fix the frame stirrup 1 and legs 4 in place
by turning the stirrup connection screws 11
clockwise into the predrilled holes (see Fig. C).
5. Place the work light with the stud bolts 9 into
the brackets 12 . Ensure that the work light is fit-
ted the right way around – with the handle 5
uppermost (see Fig. D).
CAuTIOn! Once the work light is in the
brackets
12 it can be swivelled about a hori-
zontal axis. Ensure that the work light does not
strike the floor with its lamp guard
2 . Failure
to observe this advice may result in damage to
the product.
note: Ensure that the mains lead 3 does
not become trapped between the work light
and the frame.
6. Turn the adjustment screws with the spacer
sleeves 14 clockwise into the predrilled holes
in the frame legs 4 (see Fig. E).
note: The tighter you screw in the adjustment
screws with spacer sleeves
14 , the harder it is
to swivel the work light.
7. Screw in the two locking screws 13 clockwise
using a Phillips screwdriver (see Figs. F).
8. Insert the plug into an earthed mains socket.
Your work light is now ready for
operation.
note: Retighten all threaded connections regularly.
9. Disassembly of the work light takes place in the
reverse order.
q
Switching the work light
On / OFF
i Press the ON / OFF switch 6 on the back of
the work light to switch it on.
i Press the ON / OFF switch 6 on the back of
the work light to switch it off.
Q
Maintenance
q
Replacing a lamp
WARnInG! Pull the mains plug out of the
mains socket before you carry out any task on the
device. Otherwise there is a danger to life!
note: To do this you will require a Phillips
screwdriver.
455_Arbeitsleuchte_Content_DE_GB_FR_NL_ES_IT_CZ.indd 14 18.06.09 10:20