Lingenfelter L300152012 Lingenfelter ZL1 Camaro Intercooler Fluid Reservoir 2012 v1.2 - Manual (Page 3)

Page 2.
1. Install the stud adapter (red arrow) onto the
rear airbox stud. Remove the backing paper
off of the foam mounting ring (yellow arrow)
and slide the ring over the stud adapter.
2. Install the grommet into the hole forward and
below the rear airbox stud.
3. Using Teflon thread sealant and a 7/8”
wrench, install the 90 degree fitting into the
bottom of the coolant reservoir. The open
end of the 90 degree fitting should be pointed
towards the front of the vehicle .
4. Install the coolant reservoir onto both
grommets. Make sure that the fitting which
was installed in the previous step is pointing
directly towards the front of the vehicle, as
shown in the adjacent illustration.