Audiovox MVX507 - Manual (Page 23)

Deleting a Message Individually
1 . Press @) momentarily. “C lear ?” will be displayed.
2. If you do not wish to delete the message, press
Or to execute the deletion of the message, press
“Cleared” will be displayed momentarily.
Deleting all the Messages
1. Press and hold @) for two seconds.
“RLL Clear ?” will be displayed.
2. If you do not wish to delete all the messages, press
Or to execute the deletion of all the messages, press @).
“RLL C leared” will be displayed momentarily.
Storing a Digit Message of Call Back Number
and Caller ID into Phone Number Memory
1, Press @)( r
3 ).
2. Enter XY . (XY is a location number of 01 to 89)
Or to automatically store a digit message at an unused
memory location, press @)C
5 ^ 3 ). The stored memory
number will be displayed for one second.
Notes: ■ Only digit messages can be stored.
• UNA (Number not available) and RES (Num­
ber Restricted) or Short Message will not be
stored.
Caller ID
When your phone receives a call, the caller’s phone number
will be displayed and stored in the memory. If you are in a
conversation and another call is attempted, your phone beeps
three times and the caller’s phone number will be displayed
in Call Waiting,
To answer the call, press any key except and
If you do not answer the call, the message indicator will
flash and the Caller ID will be displayed.
42
Voice Mail Access Number
1. Press to recall your Voice Mail Number.
2. In the following cases, press to place a call to the
Voice Mail Number.
• At Voice Mail Notification
• At Short Message
“MRS” display during Message Re­
view Mode
Note: It will be necessary to store your voice mail re­
trieval number in in advance to use the
one touch dialing feature.
Refer to Storing Number in L i n k D i a l i n g
Memory (Page 26).
Message Beep Alert
Your phone will beep when receiving Message services:
• Short Message......................... Repeat of single Beep
• Voice Mail Number/
Voice Mail Notification.......... Repeat of two Beeps
• Call Back Number...................Repeat of three Beeps
• Flash with Info........................ Repeat of three Beeps
Note: When Message Display Mode is the above
Beep Alert will not be repeated.
Message Beep Alert Tone Level Control
You can adjust Beep Alert tone level to seven levels
while not in use.
1. Press
The current Beep Alert Tone will be heard and the level
will be displayed.
2. Press ® or ® according to your desired tone level.
3. To clear the display, press
43