Audiovox MVX507 - Manual (Page 18)

Outgoing Call Counter
You can check the accumulated number of outgoing calls.
1. Press @ 1 , (^3^, <5Z^-
2. Enter your 2-digit Call Counter code.
Note: Please contact your authorized Audiovox dealer
to check your initial Call Counter code.
“Out 90-C KiOOi” will be displayed. (XXXX: Number of
outgoing calls)
To exit this mode, press @i.
To reset the Outgoing Call Counter to 0000, press
Note: The call counter will automatically reset to 0 after
9,999 calls.
Accumulated Call Counter
You can check the accumulated number of calls.
1, Press @), <*3^, C|^, < 2 ^.
2. Enter your 2-digit Call Counter code.
Note; Please contact your authorized Audiovox dealer to
check your initial Call Counter code.
“Total -C KtKt” will be displayed. (XXXX: Number of
calls)
To exit this mode, press @).
To reset the Accumulated Call Counter to 0000, press (^3, @)-
Note: The call counter will automatically reset to 0 after
9,999th call has been made.
To Change your Call Timer/Call Counter Codes
• In case of Call Timer code change, press
“Timer Prer” will be displayed.
• In case of Call Counter code change, press @),
“Comi-rter Pre?” will be displayed.
2. Enter the current code.
Note: Please contact your authorized Audiovox dealer
to check your initial code.
“Timer Nem?” or “Counter Heo?” will be displayed.
3. Enter a new 2-digit code.
4. Press (¿
3 ).
CAUTION: Keep the record of new codes in a safe
placet
32
Call Time Warning Tone
You can turn the Call Time Warning Tone on and off. When
it is set to on, a single warning tone will be heard every
1
minute and a double warning tone will be heard every 5 min­
utes during a call.
To l\irn the Warning Tone ON:
1. Press @), <33^ while not in use.
“Beep Tono g r," will be displayed.
2, Press @) to clear the display.
To Thrn the Warning Tone OFF:
1. Press (S^ttiB^tCil^^again while not in use. On/off
toggles and i'onp □ r ’
2. Press to clear the display.
will be displayed.
SID MANAGEMENT (Programmable Option)
You can take advantage of a family of SID (System Identifi­
cation) groups by this Programmable option. This is a group
of cellular systems in cities that your carrier owns or has
special billing arrangements with. Your close family SID’s
will be billed at the same rate as your home billing. (Both
“Hu SUC” and ROAM are off.) More distant family SID’s
will be billed at a preferred rate. Your phone will display
solid
ROAM. When flashing ROAM is displayed, you are us­
ing a SID system that is not included in the groups assigned
at the time of programming.
If your display indicates “NO SUC”, you will need to change
your A/B system selection or, please refer to Multiple City
Registration to change phone regi.stration to enable you to
make a call.
Note: For specific information regarding special billing
arrangements, please consult your cellular service
provider.
A/B SYSTEM SELECTION
You can select the system you need to use. The system that
you are registered with is the preferred system and your home
system.
1. Press @1- <1^.
2. Press 0 or ® until your desired system is displayed.
3. Press
4. Press @) to clear the display.
Note: When you turn your phone on, your phone will
start to scan the system of the last power-off.
33