USL JSD-100 Manual User Manual

Page 15

Page 14

16. 8 Channel Analog Input – Balanced line inputs. Six channels are fixed (L, C, R, LFE, Ls, Rs) and two can be set

up as either Lc/Rc or Lrs/Rrs.

17. Public Address Microphone – Dual connector with XLR and ¼” phone jack in the center.

6.4

Sixteen Channel Analog Output Rear Panel Connections (JSD-100xA)

A set of clip-on ferrite “beads” is supplied with the JSD-100. To insure the JSD-100 continues to meet FCC and CE
radio emissions requirements, one of these beads should be clipped around each cable connected to the rear
panel of the JSD-100 except for the TOSLINK, AC Power, and Bypass Power connection.

1. Bypass Power Supply – 12VDC at 1.25A.
2. Power entry Module – Accepts IEC-type line cord from 100-240VAC power source. Also contains a 500mA Slo-

Blo 5x20mm fuse.

3. Sixteen Channel Analog Output Module – Other modules include 8 channel analog and 32 channel AES.

a. Bypass crossover adjustments.
b. Main outputs cover the first 8 output channels. The Phoenix connector normally drives the power

amplifiers, and the D connector drives the booth monitor.

c. Extra outputs cover the second 8 output channels.
d. USL Link - An RJ25 connector that provides an RS-485 interface for remote volume control and other

functions.

4. Ethernet – Network communications with GUI, web browsers, automation, etc.
5. RS-232 Connector for communications with GUI or automation.
6. Automation Connector – A bidirectional port for receiving and sending automation pulses between the JSD-

100 and other system components. 12 Control lines, 11 Status lines and +5V are provided. Standard pulse to
ground system.

7. SD Card - stores the settings of the unit. Can also be used to transfer settings to another unit.
8. AES connector (DB25) – Channels 1-8 are standard. Channels 9-16 require the optional DI-80 module.
9. AES connectors (Dual RJ45s) – parallel connections to the DB25 above.
10. TOSLINK Port – Optical Fiber input for SPDIF (PCM) or optional Dolby Digital®

decoding.

11. COAX 1, COAX 2 - RCA type connectors for SPDIF (PCM) or optional Dolby Digital®

decoding.

12. Hearing Impaired/Visual Narration Outputs.
13. AUX connectors – L and R analog inputs, 300mV sensitivity.
14. Non Sync (N/S) connectors – L and R analog inputs.
15. RTA microphone – 3.5mm stereo jack with +10V on the ring, designed for use with a powered electret

microphone.

Manufactured under license from Dolby Laboratories. Dolby and the double-D symbol are trademarks of Dolby Laboratories.