Save these instructions, Important, Setup instructions – Intex CS8110 User Manual
Page 7

(131) MODEL CS8110 SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 06/28/2013
131
SAVE THESE INSTRUCTIONS
English
Page 7
SETUP INSTRUCTIONS
WATER TO
POOL
WATER FROM
POOL
1. Assemble the above-ground-pool (AGP) and its filter pump according to their installation
instructions.
2. Take the Saltwater System and its accessories out of the packaging.
3. Place the Saltwater System in line after the filter pump.
4. Connect the connector hose (8) to the Saltwater System inlet.
Connecting the system to pump and pool with 1-1/4” (32mm) connections/
hoses:
The saltwater system features 1-1/2” (38mm) connections. It is accordingly supplied
with adaptors A (1) and B (9) for connecting to the small 1-1/4” (32mm) diameter
connections/hoses. Install as follows:
Drawing #1
IMPORTANT
• The Saltwater System requires a separate filter pump [700~4000 gph (2650~15140
lph)] to drive the water and function properly.
• The Saltwater System must be installed as the last piece of pool equipment in the
water return line to the pool as displayed in Drawing #1. This location extends the
life of the titanium plates.
ID 1-1/4” (32mm)
HOSE
ID 1-1/4”
(32mm) HOSE
1
9
9
8
SALTWATER
SYSTEM
FILTER
PUMP
SWIMMING POOL