Intex CS8110 - Manual (Page 18)

(131) MODEL CS8110 SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 06/28/2013
131
SAVE THESE INSTRUCTIONS
English
Page 18
7. Boost cycle
•
If the test result is below 0.1ppm, press and hold “BOOST”
button for 5 seconds until the indicator lights up and the
LED display “80”. This indicates that the saltwater
system has started copper ion and more chlorine sanitizer
production. You can press and hold the “BOOST” button for
another 5 seconds until the indicator is off, which will cancel
the Boost cycle.
Note: Once the system has started copper ion and more
chlorine sanitizer production, the boost button can’t be re-set until
the power switch is off.
•
The boost operating hours is 8 times the amount of time programmed into the system, i.e. if
your saltwater system operating time is 2 hours, the boost procedure will run 8 x 2 = 16 hours.
After boost procedure has been completed, the system will automatically switch to the
normal working mode.
• Once the boost is operating, check whether the filter pump operating hours have been
set properly. For example, the boost operating time is 8 hours, the filter pump should be
set to run for 8 hours at least. Increase the filter pump operating time if necessary.
Note: If an Intex filter pump is attached to the system, set the pump switch to on “I”
position.
•
After a heavy rain or if the pool is dirty, press the “BOOST” button to shock the pool
again.
8. Test pool water regularly:
Once the copper level appears to be balanced, test the pool water every week to
maintain the proper sanitizer level.
It’s very important that the free chlorine is between 0.5-3.0 ppm and copper ion
concentration is between 0.1~0.2 ppm. When the copper level is below 0.1 ppm, repeat
step 7.
NOTE: A High copper ion concentration may cause blonde hair to exhibit a green hair.
To prevent this, wear a swimming cap during swimming, and wash hair with special
shampoo after using the pool. See “Troubleshooting Guide”.
9. Stand-by/power saving mode:
•
When the cycle ends, the green “SLEEP” indicator on the
control panel lights up and the LED display flashes “93”.
The system is now in Stand-By mode. After a while, it
shuts down and sets itself in a Power Saving mode. The
system will automatically turn itself back on in 24 hours,
starting its daily cycle of chlorine production.
• The “SLEEP” indicator stays on, while the system is in the
Power Saving mode. The LED display however, goes blank
after 5 minutes. Press any button ( or ) to view the last
LED code.
OPERATION INSTRUCTIONS (continued)