ILY HDD Duplicator - Manual (Page 5)

Chapter 2 - Function Introduction
1. Copy
It copies data from source HDD to target HDD(s). Please make sure
you have chosen correct copy mode you like to use. About the three copy
modes please refer to function [6.1 Copy Area] for details.
The default setting is "System and Files".
2. Compare
It is used to check if the data on source HDD is identical to target HDD(s)
after duplication.
3. Copy & Compare
It makes copy first and then compare copied HDD(s) with source HDD to
ensure data correctness.
Steps of Copy+Compare
①
Plug in a HDD into the source port, select function Copy+Compare.
②
Plug in the target HDD(s), press to confirm.
when all targets are ready, press to start copy.
Function Total data Size
Copy time and % Copied data size
④ When copy finishes, it shows the copy result.
Number of copy
passed
Number of copy
failed
5
Pass:1 Fail:0
Time 1:25
Copy x1 8000M
1:00 10% 3000M
Analyzing Source
Partition#1
Copy
Searching Source
Time
③
OK
OK