Connections, Tuning the tv to your vcr, Basic connections – Panasonic NV-SJ230A User Manual
Page 5: Preparation, Operations, 1 hold down menu button ® for 5 seconds or more, To change the rf output channel, Connections tuning the tv to your vcr
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connections
Tuning the TV to Your VCR
This section shows you how to connect the VCR to an aerial,
TV, etc.
Basic Connections
The following connections are required to record and play
back the video cassette through the TV.
Connection to a TV using the Audio/Video Input Socket:
Set the RF output channel of the VCR to [—] (RF OFF)
when the VCR is connected to the TV via the AudioA^ideo
cable. {See page 5.)
Aerial (Not supplied)
The VCR supplies a signal to the TV via the RF coaxial cable
on channel AU28-69, or NZ21 -69.
It is possible to view the video picture on your TV in the same
way that you watch TV broadcasts,
if you have connected the VCR to the TV through the Audio/
Video input sockets, then you do not need to follow the
procedure below.
Preparation
- Turn on the TV and the VCR.
Operations
1 Hold down MENU button ® for 5 seconds or more.
Set the TV to an unused position which you wish to
use for your video playback.
- Tune the TV until the display
on screen Display
shown on the right appears on the
screen. (Please refer to the TV
manufacturers operating
instructions regarding tuning.)
Panasonic VCR
3
I I
3 Press the MENU button
To Change the RF output Channel
In some rare cases after tuning the TV to your VCR,
interference may be visible on the picture. To get rid of this
interference, you can manually adjust the RF output channel
a few channels up and down from the current setting. The
procedure is described below.
Operations
1 Hold down MENU button m for 5 seconds or more.
- The VCR display changes as shown below and the VCR
picture on the TV displays this pattern.
VCR display
I I
h f - -
Panasonic VCR
2 Enter the desired channel number (AU28-69, NZ21 -69) by
the VCR Channel button
- Set the RF output channel of the VCR to [—] (RF OFF)
when the VCR is connected to the TV via the Audio/
Video cable.
Press the VCR Channel button to display [—].
For New Zealand
For Australia
21E
■69E-
28
37 — - € ^ 6 9
(Initial position)
---- ^
(RF OFF)
3 Press the MENU button m to finish the setting mode.
4 Retune your TV to the new RF channel for the VCR.
Note:
- Even if the RF output channel has been changed, it is not
necessary to perform Auto Tuning.