Hardy HI 6300 Series - Manual (Page 30)

22 Chapter 3
•
•
•
•
•
•
Load Cell Wiring Diagrams
The diagrams below show how Hardy Load Sensor with C2 wiring differs from
standard Load Cell wiring. C2 wiring is required when using a Integrated Technician
summing junction box. The C2 wires are used for communicating IT and C2
commands.
The simple wiring diagram above shows how to connect a single load cell to the HI
6300 series instrument. Note: when connecting the HI 6300 series instrument to a
junction box, the sense lines would be connected between the +Sen and –Sen
Connections for the junction box and the instrument.
Industry standard load cells wiring Hardy load sensor C2 wiring
WARNING - Instrument power should be routed away from all other signal
cables to avoid electrical interference.
AVERTISSEMENT – Tension de l'appareil doivent être acheminés à l'écart de
tous les autres câbles de signaux pour éviter toute interférence électrique.