FRITSCH PULVERISETTE 6 classic line - Manual (Page 8)

GTM-System page 5
1.5 General Safety Instructions
• The instrument can only to be used for the purpose described
• Use only original accessories and original spare parts. Failure
to do so may result in dangerous situations.
• The operators must be familiar with the contents of the operat-
ing instructions.
To this end, for example, the operating instructions must re-
main close by the instrument.
• Do not remove labels
• At all times keep in mind strict safety precautions while operat-
ing the instrument.
• Unauthorized modification of the instrument or any part
thereof will result in the loss of the conformity to European di-
rectives which are asserted by Fritsch and the warranty.
• Use the instrument only inside. The air must not contain any
electrical conductive dust.
• Use the measuring system only in the Planetary mills of the
“FRITSCH GmbH".
• The instrument is not explosion-proof and is unsuitable to
grind or sieve materials which are explosive, combustible or
promote combustion.
• Operate the GTM system within its set operating parameters.
• Don't use the GTM system unsupervised.
• Keep an eye on movements of the mill and correct if neces-
sary the mass-distributions.
• Keep an eye on slide-movements of the grinding-bowl and in-
crease if necessary the tension of the chuck.
• Replace screws, which have worn out threads.
• Use the measuring system only in dry environments.
• Heed the security-hints of the instruction manuals of the
Planetary mills.
• Calculate the enthalpie of the possibly originating new con-
nection before use of the GTM system. Ensure that only a lim-
ited amount of grinding substance is filled into the grinding-
bowl to avoid that the produced heat does not exceed
30kJoule.
• Do not fill the grinding-bowl with any liquids when measuring.
• Don't expose yourself unnecessarily to the emitted radio
waves.
• Before you switch on the mill pull the charging cable from the
transmitter unit!