Dubbing, Ag-5210 for playback, Ag-5210 for recording – Panasonic AG-5210 User Manual

Page 11: Operation, Auto off output ctl output

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

AUTO OFF Output

CTL Output

If any trouble should occur, this unit is set to AUTO OFF.

At such a time, the unit stops automatically, and the REC

Lamp flashes. At the same time, signals are output from
the AUTO OFF OUT Connector on the rear panel. When
the Power Switch is set off, AUTO OFF is released.

The CTL signal to be recorded on the tape is output in
the form shown in the figure below. It can be used for
the tape travel count, etc.

OPEN

(Max. 12 V)

OV at AUTO OFF

OPEN

(Max. 12V)

Standard
speed: 33.35mm/s

Dubbing

Refer to the figure below for the connections which apply when using two VTRs for dubbing.

Audio Cable (phono)

AG-5210 for playback

• Memory Button: OFF
• Load the pre-recorded tape.

AG-5210 for recording

• Memory Button: OFF

• Load the unrecorded tape.

Operation

Press the PLAY Button on the playback VTR to start

playback.

® Press both the REC and PLAY Buttons on the record

ing VTR at the location where the dubbing is to begin,

and proceed with dubbing.

the recording VTR and then press the STOP Button
on the playback VTR.

• With 6-hour recording for dubbing purposes, use the unit

with the Fli-Fi REC Switch at the OFF position.

- 11 -