Panasonic NV-SD230A - Manual (Page 18)

NTSC CONVERTER
When playing a NTSC game connected to this VCR via a
PAL system TV, set NTSC CONVERTER to ON.
Follow steps 1 to 2 of TAPE SELECT.
3 Select NTSC CONVERTER.
cX>
4 Select ON or OFF.
OFF: Normally set at this position.
ON:
PAL TV can receive signals from NTSC 3.58
signal source {e.g., NTSC game machines.)
connected to the VCR main unit. However,
when recording, this function does not work.
• When receiving NTSC 4.43 signals, this function does
not work correctly.
Press MENU twice to make the on screen display
disappear.
(MENU'
POWER SAVE
Follow steps 1 to 2 of TAPE SELECT.
3 Select POWER SAVE.
CD
CD
NTSCINPUT SELECT
NTSC PB SELECT
NTSC CONVERTEP
JET REWIND
POWER SAVE
4 Select ON or OFF.
ON: This setting makes the display disappear when
the VCR is off.
It will not operate in the Timer standby mode.
After recording all programmed data, the VCR will
go into Power save mode.
OFF: This setting does not conserve power when the
VCR is off.
Press MENU twice to make the on screen display
disappear.
(MENU
JET REWIND
This function enables the tape to rewind at the 360 times
speed.
Follow steps 1 to 2 of TAPE SELECT.
3 Select JET REWIND. CD
CD
TAPSfialcT (E1B0)
HTSC INPUT SELECT {AUTO)
NTSC PS SELECT {onPALT^
NTSC CONVERTER (OFF)
JET REWIND
POWSISAVE (6 ff ^
4 Select ON or OFF.
• Select OFF if you wish to rewind the VCR slowly.
5 Press MENU twice to make the on screen display
disappear.
(MENU
18