Basic operation, Before starting play, Playing a disc – Yamaha DVD-C920 User Manual

Page 15: Preparation, Ii press power to turn the power on, Press ^ (or open/close) to open the disc tray, El load discs, Press > (play)

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

BASIC OPERATION

Before starting play

To play a disc properly, you need to adjust the formats of audio and video signals output from this unit in accordance with the

equipment connected to this unit. See p.25 to 27.

CAUTION

If your AV amplifier does not incorporate DTS decoder and you have connected this unit and the amplifier through
digital terminals, please make sure that the ‘DTS Digital Surround’ at ‘Audio’ SETUP MENU is set to PCM (factory
setting). Otherwise, unprocessed digital signals will be output and its noise could damage your ears and your speakers.

Playing a disc

□ QEDQ
GDHQGD

CDEDBD

1=5'Bo

“o' o o o

o o o a

(PLAY)

■ Preparation

Select DVD as the input source on your AV amplifier.

Press POWER to turn the power on.

Press ^ (or OPEN/CLOSE) to open the disc

tray.

El Load discs.

Use the disc guides (numbered, 1 to 5) to align the
discs correctly.

□ Press > (PLAY).

The disc tray closes and playback starts. This unit plays
all discs on the tray in sequence.

\ « /

• If necessary, select a desired disc using DISC SKIP or one of the

DISC 1, 2, 3, 4 or 5 buttons.

• When a menu screen appears I

DVD-A1

DVD-V

See ‘Using a Disc’s Menu’ in p.l4.

Notes

• When this unit finishes playing a DVD, this unit stops playback or

shows the menu screen and does not start playing the next disc.

• This unit cannot play a CD-R or CD-RW disc unless the disc has

been finalized. Please make sure to finalize the disc on the CD

recorder before playing it on this unit.