Yamaha SPX90 II - Manual (Page 20)

PAN- TRIGGERED PAN
This program automatically pans the sound image
between left and right in the stereo sound field. Pan
direction, speed, and phase can be programmed.
1. PAN SPEED. Range: 0.1
Sets the speed of pan.
40.0 Hz
2. DIRECTION. Range: L -> R, L
Determines the direction of pan.
R. L-
3. DEPTH. Range: 0 -100%
Sets the degree of level variation. The higher the
value, the stronger the pan effect.
In this program the pan effect is triggered by the input
signal or footswitch.
1. TRIGGER LEVEL. Range: 1 - 100%
Determines the strength of the attack signal required
to trigger the pan effect. The higher the value, the
higher the input signal level required to trigger the
effect.
2. TRIGGER DELAY. Range: -100 - 100 msec
Produces a delay between the time at which the
effect is triggered and that at which the pan effect
actually begins. If a negative value is programmed,
the input signal is delayed so that effectively,the
pan effect begins before the signal appears.
3. TRIGGER MASK. Range: 5 - 32,000 msec
This parameter makes it impossible to re-trigger the
pan function until the programmed time has
elapsed.
4. ATTACK TIME. Range; 5 msec - 32,000 msec
Determines how quickly or slowly the pan effect
reaches maximum depth after it is triggered.
5. PANNING TIME. Range: 5 msec - 32,000
msec
Determines how long the maximum-depth pan
effect remains active.
6. RELEASE TIME. Range: 5 msec - 32,000
msec
Determines how long it takes for the pan effect to
fade out after the PANNING TIME has elapsed.
7. DIRECTION. Range: L -R, L ^R
Sets the direction of pan.
8. LPF. Range: 1.0 kHz - 11 kHz, THRU
Determines the cutoff frequency of the low-pass
filter.
9. DELAY. Range: 0.1 - 1800.0 msec
Sets the delay time of equalized signal following
the direct signal.
NOTE: To use footswitch FC-5, connect the FC-5
to the MEMORY/TRIGGER FOOT Switch
jack and press the Foot Trigger key.
19