Panasonic AW-PH650 - Manual (Page 9)

Parts and theirfunctions
■Main unit (Pan/tilt head)
O © Q O ©
QMain unit cover
The sunshade cover and main unit cover must be
removed when the cable compensation circuit or landing
characteristics are to be changed.
@Grip
Used in carrying, installing, or lifting the pan/tilt head.
©Sunshade cover
This cover protects the pan/tilt head from direct exposure
to sunlight.
O Rotary arm
Mount the housing after having installed the housing
mount frame.
© l/F connector
Connect this to the l/F connector of the camera housing.
©Anti-fall wire bolt
This bolt fastens the anti-fall wire which prevents the
pan/tilt head from falling from its installed position.
o Pan/tilt head mounting holes (X4)
These holes are used to install and secure the pan/tilt
head.
© Multi connector [MULTI]
The supplied multi cable is connected here.
©Coaxial connector [SDI OUT]
This is used for outputting the SDI or other signals which
have been input from ©.
©Option connector [OPTION]
The control signals of the controller's OPTION button are
output from this connector.
Be absolutely sure to use a water-proof cable.
The compatible connector is the R28-P8M4.8 made by
Tajimi Electronics Co., Ltd.
Afilter (supplied) must be
installed around the cable.
Install it at a distance within
30 mm from the connector.
Waterproof the filter using
tape or tube, for instance.
OPTION
Within 30 mm
from connector
* Service connector
(View of connector as seen
from the cable)
Cable
Filter
©Power connector [POWER]
The supplied power cable is connected here.
©Grounding bolt
This bolt is used to connect the wire for system grounding
(frame grounding bolt).
©Coaxial connector [SDI IN]
When an SDI card is installed in the camera, this
connector is connected to the SDI signal output
connector.
8(E)