Panasonic NV-J35 - Manual (Page 9)

TUNING THE TV SETTO THE VIDEO PLAYBACK CHANNEL
The adjustments described on this page are not necessary,
if the VTR is connected to the TV set via the Video/Audio
output sockets.
Video Playback Channel Selector
This switch is used to select the Video Playback channel
which is not occupied with any TV station. [NV-J35A; 0 or
1;NV-J35EA; 2or3]
<1
9
Q Turn the TV set on and select the programme position
that is not occupied by any TV station.
@ Press the VTR On/Off Switch to turn the VTR On.
(FRONTSIDE)
O
VTR □
• The corresponding indicator lights up.
Q Set the VTR/TV Selector to “VTR".
(FRONTSIDE)
VTR/TV
□
• VTR/TV Indicator will appear in the Multi-Function
Display.
Q Set the Test Signal Switch to “On".
CD
OFF ON
TEST
SIGNAL
@ Tune your TV to VHF channel as shown below.
Confirm by your TV that the received test pattern is as
shown below.
NV-J35A: VHF channel 0 or r
NV-J35EA: VHF channel 2 or 3
NV-J35A only
*ln some areas
channel 0 may be
used by local TV
station. In this case
switch to channel 1,
@ Set the Test Signal Switch to “Off”. Your TV is now
ready to receive the RF output signai from the VTR.
Q To check, playback a pre-recorded tape and confirm
that the picture quality is satisfactory.
;9)