Panasonic NV-G21 - Manual (Page 27)

O VTR On/Off Switch
For turning the VTR on and off.
^ Programme Position (Channei) Selector Buttons
O Record Buttons (•)
To start recording, press the both buttons simul­
taneously.
O Pause/Still Button (II)
0 Stop Button (■)
0 Rewind '4'4/Review @ Button
When this button is kept pressed during playback, the
VTR changes over to the Review playback mode.
O Play Button (^}
O Slow Button (!•-)
Press the Slow Button for slow-motion playback at Vio
of normal speed. The stow playback speed can be
varied between
V 25 and Vs of normal speed by using
the and Buttons.
Note:
If the VTR is left in the slow playback mode for more
than 5 minutes, the VTR will automatically switch over
to the stop mode, to protect the tape and the video
heads.
•Adjust the Slow Tracking Control if necessary.
© Double Speed Playback Button (X2)
When this button is kept pressed during playback, the
VTR changes over to the Cue playback mode.
Still Advance button (!!►)
VTR/TV Selector
(D
0
Power Source for the Infra-red Remote
Controller
■ The Infra-red Remote Controller is powered by two I EC
“R6” size batteries. The life of the batteries is about one
year, however, it depends on the frequency of use.
Inspect and if necessary, replace the batteries once a
year.
CAUTION FOR BATTERY REPLACEMENT
•Load the new batteries with their polarities (0 and ©)
aligned correctly.
•Do not apply heat to batteries, or internal short-circuit may
occur.
•If you do not intend to use the Remote Controller for a long
period of time, remove the batteries and store them in a
cool and dry place.
•Remove spent batteries immediately and dispose of them.
•Do not use an old and a new batteries together. (Also
never use an alkaline battery with a manganese battery.)
Load the batteries as follows:
O Remove the battery com­
partment lid.
© Place two batteries in the
battery compartment as
indicated inside the bat­
tery compartment.
o Replace the lid.
•The infra-red beam should be transmitted directly at the
Infra-red Remote Control Receiver on the front of the
VTR.
•Direct sunlight may interfere with the beam.
•The iightsensing angle of the Infra-red Remote Control
Receiver window in the VTR is about 60°.
•The unit should be used within a range of about 7 meters