Warpia SWP700 - Manual (Page 10)

9
l Press "Delete" or "Menu" to select "Remove video source"
l Select the device to be deleted and press "OK"
l After deleting the device, press "Source" to ensure the device no longer exists
l Other devices can be also deleted as per the above procedure
5.3 Modify source equipment name
l Press "Menu" to select "Modify video source name" on the screen
l Select the source to be modified and press Up and Down button to modify
l Press the Right and Left button to select characters to be modified; pay attention the name of
the video source. Name should not be left blank
l Press "OK" after finishing modification
5.4 Disconnect Network
l Press "Menu" to select "Disconnect Wireless link"
l Press "OK" to ensure disconnection
l Network disconnects when "Wireless off" is shown on the screen
5.5 Change Audio/Video interface or video source
l Press "Source" to ensure at least two video sources exist when the device is normally
connected and audio and video transmit fluently
l Press "Next Source" to change to next video source
l Press "Pre Source" to change to previous video source
5.6 Functions of the buttons on WHDI Remote Control
Item Key Function
1
PWR Standby key; available to Transmitter and Receiver
2
Add To add video source to device list; available to Receiver
3
Delete
To delete Receiver from device list or delete character of the
device name; available to Receiver
4
MENU Menu; available to Receiver
5
Guest Temporary visit key; available to Receiver
6
To up; available to Receiver